سال انتشار: ۱۳۸۶

محل انتشار: دومین کنفرانس بین المللی و هشتمین کنفرانس ملی مهندسی ساخت و تولید

تعداد صفحات: ۱۳

نویسنده(ها):

M.J Haddad – Ph.D. Student, Manufacturing Engineering Group, Tarbiat Modares University, Tehran, Iran
A Fadaei Tehrani – Assist. Prof., Manufacturing Engineering Group, Isfahan University of Technology, Isfahan, Iran
A Mohammadi – Lecturer, Education Workshop Center, Isfahan University of Technology, Isfahan, Iran
N Nehzat – Assist. Prof., Manufacturing Engineering Group, Isfahan University of Technology, Isfahan, Iran

چکیده:

In this paper, the effects and optimization of machining parameters on material removal rate (MRR) in Cylindrical Wire Electrical Discharge Turning (CWEDT) process is investigated. Material removal rate is chosen as the machining parameters to verify the process. In addition, power, voltage, pulse off time and spindle rotational speed were adopted for evaluation by Taguchi method. A L9(34) Taguchi standard orthogonal array is chosen for the design of experiments. The level of important of the machining parameters on the material removal rate is determined by using analysis of variance (ANOVA). The optimum machining parameter combination was obtained by using the analysis of signal to noise (S/N) ratio. The variation of material removal rate with machining parameters is mathematically modeled by using regression analysis method. Finally, experimental tests were carried out to identify the effectiveness of this proposed method.