سال انتشار: ۱۳۸۴

محل انتشار: اولین کنفرانس بین المللی و هفتمین کنفرانس ملی مهندسی ساخت و تولید

تعداد صفحات: ۱۰

نویسنده(ها):

M Mirzaei – Mechanical Engineering Department, Tarbiat Modarres University, Tehran, Iran
H Mohammad Hosseini – Mechanical Engineering Department, Iranuniversity of Science and Technology, Tehran, Iran
SH Azari – Mechanical Engineering Department, Iran university of Science and Technology, Tehran, Iran

چکیده:

This paper reports the finite element modeling of the electric-arc welding process for the assessment of the resultant residual stresses for two specific geometries. The simulation procedure was first carried out for a Butt-Weld geometry for which two different methods, i.e. the heat-flux-input and the prescribed-temperature, were used to obtain the temperature field. The obtained results were compared and the accuracy of these two methods was investigated. Next, the method of prescribedtemperature was used to obtain the temperature field induced by arc welding in a Tjoint- fillet weld and, conducting a thermo-elasto-plastic analysis, the residual stress distribution and distortions were computed. To simulate the effect of addition of the filler material during welding, the element birth technique was used. The results obtained for these two geometries were compared with similar results reported in the literature.