سال انتشار: ۱۳۸۴

محل انتشار: اولین کنفرانس بین المللی و هفتمین کنفرانس ملی مهندسی ساخت و تولید

تعداد صفحات: ۱۰

نویسنده(ها):

M.H Parsa – Associate Prof.-Metallurgical engineering Dept.-Tehran university
A.M.A Pazooki – MSC student-Metallurgical engineering Dept.-Tehran university
M Nili Ahmadabadi – Professor-Metallurgical engineering Dept.-Tehran university-Iran.

چکیده:

Prediction of material properties and behaviour during the process is important in any metal forming process such as flow forming. In flow forming, previous works were based on trial and error methods. The most useable test for studying the flow formability of materials is to reduce the thickness of a tube from initial to the lowest possible thickness. Then flow formability is defined as the maximum thickness reduction before fracture. Accurate determination of effects of parameters involved in the flow formability test became possible only recently when the FEM was introduced. In this paper the effect of process parameters such as attack angle and effect of feed rate on flow formability of high strength steels isinvestigated using ANSYS-LS DYAN version 9. The simulation results compared to experiments.