سال انتشار: ۱۳۸۶

محل انتشار: بیست و دومین کنفرانس بین المللی برق

تعداد صفحات: ۹

نویسنده(ها):

Kourosh Mousavi Takami – TDI and KANTHAL researcher and so Ph.D. student in Mälardalen University، TDI Institue, Mälardalen University and KANTHAL co., Sweden
Örjan Danielson – Ph.D. in KANTHAL، TDI Institue, Mälardalen University and KANTHAL co., Sweden
jafar Mahmoudi – Professor in Mälardalen University، TDI Institue, Mälardalen University and KANTHAL co., Sweden

چکیده:

Super heater elements concentrated in very high and clean power at temperature up to 1800 ºc is needed for aluminum melting, oil drying
equipment using for power transformers and same that material. There fore, always it is need to minimize power consumption and increase effectiveness at power reflector customers. This means to minimize heat losses in the High Power Reflector, and to optimize heat performance with respect to output power and temperature distribution. This can be done by altering the size and form of the insulating ceramic fiber to have
as much power as possible ‘reflected’ out from the module. It can also be done by altering the size and form of the element. It has been done andthe t ask solved mainly by heat transfer simulations, using COMSOL and MATLAB software’s. To minimize the number of different designs (and
thus the number of calculations) were studied; it is also done that statistical methods for experimental design used to determine which designs should be used in the calculations. When an optimal solution has been found, for verification, it has been tested at Kanthal’s facilities, with two reference designs.